P/N: 4809654
©2005 Paxton Automotive
All Rights Reserved, Intl. Copr. Secured
29JUL05 v2.0 05MusGT(4809654v2.0)
12-3
*** NOTE ***
Install the MAF sensor element so the inlet of the
sensor faces the air filter. (See Fig. 10-h.)
L. Install the MAF sensor and air filter to the 180°
duct. (See Fig. 12-h.)
O. MAF (Mass Air Meter) Harness Extension
(Non-cooled kits only):
1. Locate the supplied wire and butt connec-
tors in assembly 4FU139-096.
*** NOTE ***
It is strongly recommended that the wires be sol-
dered. Temporary solderless connectors have
been provided in case you are unable to solder.
2. Remove the split loom from the factory
wires on the MAF (Mass Air Meter) sen-
sor.
3. Cut the wires to the connector approxi-
mately 2" from the plug.
4. Using the supplied connectors and wire
extend the connector to the MAF.
5. Install the supplied 3/8" split loom to the
extended sensor plug. Secure the split
loom with wire-ties or tape.
6. Route the lengthened wires and connector
to the MAF, keeping the wires away from
hot or moving parts.
M. Install the 180° duct and the MAF sensor with
filter to the inlet duct leading to the
Supercharger. (See Fig. 12-i.) Clock the MAF
exactly as shown in the Figure. MAF, keeping
the wires away from hot or moving parts.
N. Secure the rear clamp at the inlet duct union to
the previously installed support bracket. (See
Fig. 12-i.)
Fig. 12-i
Fig. 12-h
AIR INLET
SUPPORT BRACKET
12. AIR INLET ASSEMBLY, cont’d
