P/N: 4809654
©2005 Paxton Automotive
All Rights Reserved, Intl. Copr. Secured
29JUL05 v2.0 05MusGT(4809654v2.0)
13-1
Section 13
FUEL PUMP UPGRADE
A. Remove the rear seat by depressing the two
release buttons at the front edge of the seat.
(See Fig. 13-a.)
E. Slowly pull the fuel pump assembly up. Locate
the cross-over fuel line connection on the fuel
pump assembly and disconnect. (See Fig.
13-c.)
F. Remove the pump assembly from the tank
being careful not to damage or lose the rubber
O-ring.
G. Carefully cut the step-less clamps securing the
short corrugated fuel line between the fuel
pump outlet and distribution rail. Remove the
fuel line and discard. (See Fig. 13-d.)
C. Unplug the sending unit harness and disconnect
the fuel line connection.
D. Using a small screwdriver or chisel and ham-
mer, tap the retaining ring in a counter clock-
wise direction. Remove the retaining ring and
set aside. (See Fig. 13-b.)
B. Remove the round plastic inspection cover on
the driver’s side. (See Fig. 13-b.)
Fig. 13-a
Fig. 13-b
Fig. 13-c
13. FUEL PUMP UPGRADE
FUEL LINE
CONNECTION
RECEIVING DOTS
ON EACH EAR
RETAINING
RING
HARNESS
CONNECTION
CROSS-OVER
LINE CONNECTION
*** NOTE ***
This section is best performed with the fuel level
BELOW half a tank.
Fig. 13-d
DISTRIBUTION
RAIL
PUMP
DISCHARGE
