Filter
Top Products
88
Plotter screen showing Find Waypoint.
7. To clear the search and return to the last page displayed, press
EXIT|EXIT. (Before you completely exited out of the Search menus, you
could have gone looking for another place.)
Navigate To a Waypoint
You can select any waypoint visible on the Plotter Page with the cursor,
then use the Navigate to Cursor command (we described how to do that
earlier in this section). However, you can avoid scrolling the plotter to
pick your waypoint if you use the Find Waypoint commands:
1. Press
WPT. To look up the nearest waypoint, just press ENT; or, to
look by name (and scroll through the entire waypoint list), press ↓ to
FIND BY NAME|ENT. For this example, look by name.
2. If your waypoint list is a long one, you can spell out the waypoint
name in the
FIND BY NAME box to search for it. (Press ↑ or ↓ to change the
first character, then press → to move the cursor to the next character
and repeat until the name is correct, then press
ENT to jump to the list
below.)
3. If the list is short, you can jump directly to the
FIND IN LIST box by
pressing
ENT. Use ↑ or ↓ to select the waypoint name, press ENT and
the waypoint information screen appears with the
GO TO command se-
lected.
4. To begin navigating to the waypoint, press
ENT.