Filter
Top Products
1-19
8. Pass the signal cable through the cable entry at the bottom of the antenna base. Two
plugs are provided at the end of the cable for connection inside the unit.
9. Secure the cable with the cable clamping plate and gasket. Ground the shield cable by
using one of the fixing screws for the cable clamping plate. See the figure in above.
10. Mate the two plugs with the jacks on the INT Board.
11. Close the antenna housing cover temporarily, because it may have to be opened again
for adjustment after installation. Now is the time to begin the procedure for fixing the
antenna radiator to the radiator bracket.
For Alternative Mounting
When the antenna unit is reversely mounted, the magnet must be relocated, otherwise the
radar screen always the stern view!
Bearing Retainer
Magnet
The other mounting location for
the magnet
(cannot be seen in this figure.)
Place of magnet