Filter
Top Products
3-3
Contents of Network setup menu
Item Description Default Setting
Mono:
172. 031. 003. 004
IP ADDRESS This address is assigned at the factory. Change the
address (last three digits; 001 to 254) when like
models are connected directly or through the hub. Do
this change before connecting the equipment to the
other equipment or hub to distinguish. Do not set the
same IP address in the network.
17X2C: 172. 031. 003. 001
17X3C: 172. 031. 003. 005
HOST NAME Set the name for your display unit to distinguish it from
others in the NavNet system. Confirm that two
equipment don’t have same host names. The host
name has been preset depending on the series of
NavNet. See the table in below. This host name is
used for RADAR SOURCE and CHART SOURCE.
RADAR
RADAR SOURCE Enter the host name “RADAR (preset)” or the new
name set at HOST NAME item setting if the unit has
been changed of the network radar to use for the radar
display.
RADAR
CHART SOURCE Enter a host name (set at HOST NAME) of network
display unit to select equipment which has chart card
in its slot (Max. three units, excluding own) to use.
None
SOUNDER
SOURCE
The host name of the network sounder ETR-6/10N or
ETR-30N is preset (SOUNDER) to use for the video
sounder display. Clear the host name when no
network sounder is connected.
SOUNDER
SUBNET MASK 255.255.000.000
GATEWAY
ADDRESS
000.000.000.000
OFFSET PORT
NUMBER
Not used. Reserved for future use.
10000
NavNet equipment default settings
Model IP ADDRESS HOST NAME
MODEL1722/1732/1742/1752/1762 172.031.003.004 RADAR
MODEL1722C/1732C/1742C/1752C/1762C 172.031.003.001 RADAR
MODEL1833/1933/1943/1953 172.031.003.002 RADAR
MODEL1723C/1733C/1753C/1763C 172.031.003.005 RADAR
MODEL1833C/1933C/1943C/1953C 172.031.003.003 RADAR
GD-1700/1700C 172.031.014.001 PLOTTER
GD-1900C 172.031.003.003 PLOTTER
GD-1710C 172.031.014.005 PLOTTER