Filter
Top Products
4-6
Assembling BNC connector (CN-A7, CN-A8, CN-A9, CN-A10,
CN-A11, CN-A12)
Housing Clamp Washer Nut
Gasket
Center pin
15
1
2
Shield
3
3
4
5
6
1. Remove vinyl sheath of the cable by
15 mm.
2. Pass the cable through the nut, washer,
gasket and clamp.
3. Unravel the shield and fold it back
onto the clamp.
4. Shorten the insulator, leaving 3 mm.
5. Trim the shield as shown in the
drawing. Solder the center pin to the
conductor of the cable.
6. Pass the cable through the housing
and tighten the nut.
Figure 4-8 Assembling BNC connector