Filter
Top Products
1. OPERATION
18
3. Press the MARK or ENTER key to regis-
ter the position set at step 2. A red vertical
line appears on the position set at step 2.
The waypoint is automatically named with
the next sequential waypoint number. If
you want to change waypoint name, go to
step 4. Otherwise, go to step 6.
Note 1: When [TLL] or [FURUNO-TLL] is
selected at [TLL Output] on the [NMEA]
menu of the [System] menu, the latitude
and longitude position at the cursor posi-
tion is output to the navigator.
Note 2: If you attempt to enter more than
20 waypoints, the message "Already en-
tered 20 waypoints. No more waypoint
can be entered." appears. In this case,
erase an unwanted waypoint to enable
entry. (See paragraph 1.19.3 for details.)
However, the L/L position is output to the
connected equipment.
4. Press the ENTER key to open the way-
point name entry box.
5. Enter the waypoint name (Max. 8 charac-
ters).
6. Press the MENU/ESC key to close the
window.
How to register a waypoint by manual
entry of latitude and longitude
1. Open the menu, select [Data] and press
the ENTER key.
2. Select [WPT List] and press the ENTER
key.
3. Select an empty waypoint and press the
ENTER key. The Waypoint setting win-
dow appears. [Lat] and [Lon] show the
current position.
4. Select item desired and press the ENTER
key to show corresponding input box.
01
*: Go to WPT
and WPT
List are
inoperative
when no
latitude and
longitude
position is
input (to the
12-24
VDC/NMEA
port).
*
*
Waypoint name Latitude Longitude