Filter
Top Products
SAFETY INSTRUCTIONS
iii
WARNING CAUTION
Turn off the power at the switchboard
before beginning the installation.
Fire or electrical shock can result if the
power is left on.
Be sure no water leaks in at the
transducer or sensor mounting
location.
Water leakage can sink the vessel. Also
confirm that the transducer and/or
sensor will not loosen by ship's vibration.
The installer is solely responsible for the
proper installation of the equipment.
FURUNO will assume no responsibility
for any damage associated with
improper installation of the transducer.
Use the specified power cable.
Use of other power cable can cause fire.
Do not install the transducer or sensor
where air bubbles and noise are
present.
Performance will be affected.
The following are guidelines for
handling of the transducer cable.
- Keep fuels and oils away from the
cable.
- Locate cable in a safe place.
- Do not paint the cable.
The sheath of the cable is made of
chloroprene rubber (or polychloride
vinyl). For this reason do not paint the
cable.
Do not turn on the equipment with the
transducer out of water.
The transducer can be damaged.
Observe the following compass safe
distances to prevent interference to a
magnetic compass:
Safety Instructions for the Installer
A warning label is attached to the display unit.
Do not remove the label. If the label is missing
or damaged, contact a FURUNO agent or
dealer about replacement.
FCV-627
Name: Warning Label (1)
Type: 86-003-1011-3
Code No.: 100-236-233-10
Warning Label
Display
unit
Standard
compass
Steering
compass
FCV-627
0.4 m
0.3 m
FCV-587
0.35 m
0.3 m
WARNING
To avoid electrical shock,
do not remove cover.
No user-serviceable parts
inside.
FCV-587
Name: Warning Label (2)
Type: 03-129-1001-3
Code No.: 100-236-743-10
WARNING
To avoid electrical shock, do not
remove cover. No user-serviceable
parts inside.