Filter
Top Products
4. INSTALLATION
39
525STID-PWD
The optional transom mount triducer
525STID-PWD can be installed by the thru-
hull method or the inside-hull method.
Pre-test for speed and temperature
Connect the sensor to the instrument and spin
the paddlewheel. Check for a speed reading
and the approximate air temperature. If there
is no reading, return the sensor to your place
of purchase.
Tools and materials needed
Mounting location
To ensure the best performance, the sensor
must be submerged in aeration-free and tur-
bulence-free water. Mount the sensor close to
the centerline of the boat. On slower heavier
displacement hulls, positioning it farther from
the centerline is acceptable.
Allow adequate space above the bracket for it
to release and rotate the sensor upward.
Note 1: Do not mount the sensor in an area of
turbulence or bubbles: near water intake or
discharge openings; behind strakes, struts,
fittings, or hull irregularities; behind eroding
paint (an indication of turbulence).
Note 2: Avoid mounting the sensor where the
boat may be supported during trailering,
launching, hauling, and storage.
Note 3: For single drive boat, mount on the
starboard side at least 75 mm (3") beyond the
swing radius of the propeller.
Mounting location on single drive boat
Note 4: For twin drive boat, mount between
the drives.
Installation of bracket
1. Cut out the installation template (en-
closed with transducer) along the dotted
line.
2. At the selected location, position the tem-
plate, so the arrow at the bottom is
aligned with the bottom edge of the tran-
som. Being sure the template is parallel to
the waterline, tape it in place.
Positioning the template
Warning: Always wear safety goggles
and a dust mask.
• Scissors • Masking tape
• Safety goggles • Dust mask
• Electric drill • Screwdrivers
• Drill bit:
For bracket holes: 4 mm, #23, or 9/64"
For fiberglass hull: chamfer bit (preferred),
6 mm, or 1/4"
For transom hole: 9 mm or 3/4" (optional)
For cable clamp holes: 3 mm or 1/8"
• Straight edge • Silicone sealant
• Pencil • Cable ties
• Water-based antifouling paint (mandatory in
salt water)
Height
Height without
speed sensor
191 mm (7-1/2")
Height with
speed sensor
213 mm (8-1/2")
75 mm (3")
minimum beyond
swing radius
Align template vertically.
Deadrise angle
Slope of hull
Parallel to
waterline
Align template arrow with
bottom edge of transom.