Filter
Top Products
19
NAV DATA-1, -2: Choose the number of
navigation data items to display on the nav
data displays, from two, three or four items.
Requires appropriate nav data.
KEY BEEP: Turn key beep on or off.
BATT VOLTAGE: Turn the battery voltage
indication (appears at the top right corner
on the screen) on or off. When on it
replaces the picture advance speed
indication.
Page 2
NAV DISPLAY: Choose the nav data to
display in the nav data window at the top
left-hand corner. You may choose from
temperature/speed, latitude/longitude,
range and bearing, course over ground, trip
distance or wind speed. Requires
appropriate nav data.
40.7°F
16.2kt
Nav window (water temperature and speed)
NMEA0183: Choose NMEA version of
navigator; Ver. 1.5, Ver. 2.0 or Ver. 3.0.
TLL OUTPUT: Enables/disables output of
TLL (Target Latitude, Longitude) position
when the [MARK] key is operated. “TLL”
outputs latitude and longitude position.
“FURUNO-TLL,” available with connection
of navigator that can output FURUNO TLL,
outputs latitude and longitude, water
temperature, depth, etc.
BEARING: Ship’s course and bearing to a
waypoint may be displayed in true or
magnetic bearing. Magnetic bearing is true
bearing plus (or minus) earth’s magnetic
deviation. Requires bearing data.
WIND SPD/DIR: Choose the wind speed
and direction reference from true and
apparent. Requires wind sensor.
Apparent: The direction (in relation to
ship’s bow) and speed of the wind as it
appears to those on board, relative to the
speed and direction of the boat;
combination of the true wind and the wind
caused by the boat's movement.
True: The speed and direction (in relation
to ship’s bow) of the wind felt or measured
when stationary.
TRIP SOURCE: Choose speed source for
the trip distance indication; Own
(transducer w/speed sensor or separate
speed sensor) or NMEA.
TEMP SOURCE: Choose source of water
temperature input; Off, Own (transducer
w/water temperature sensor or separate
temperature sensor), or NMEA.
SPEED SOURCE: Choose source of speed
input; Off, Own (transducer w/speed sensor
or separate speed sensor), or NMEA.
Requires speed data.
TEMP CALIB.: If the water temperature
sensor-generated water temperature
indication is wrong, you can correct it here,
when “Own” is selected as temperature
source. For example, if the water
temperature indication is 2° higher than
actual water temperature, enter -2. The
setting range is -40°F to +40°F.
SPEED CALIB.: If the speed
sensor-generated speed indication is wrong,
you can correct it here, when “Own” is
selected as speed source. For example, if
the speed indication is 10% lower than
actual speed, enter +10. The setting range
is –50% to +50%.