Filter
Top Products
28
No.1
M5 x 14
5 x 20
5 x 20
5
Tape
Transom mount transducer,
mounting flush with hull
Installing the transom mount
transducer on a deep-V hull
This method is employed on deep-V hulls
and provides good performance because
the effects of air bubbles are minimal.
Install the transducer parallel with water
surface; not flush with hull. If the boat is
placed on a trailer care must be taken not
to damage the transducer when the boat is
hauled out of the water and put on the
trailer.
5 x 20
No. 2
M5 x 14
5 x 20
Transom mount transducer,
mounted projecting from hull
Transducer preparation
Before putting the boat in water, wipe the
face of the transducer thoroughly with a
detergent liquid soap. This will lessen the
time necessary for the transducer to have
good contact with the water. Otherwise the
time required for complete “saturation” ill be
lengthened and performance will be
reduced.
DO NOT paint the transducer. Performance
will be affected.