Filter
Top Products
190-00906-01 GTX 23 Installation Manual
Rev. C Page C-3
APPENDIX C Interconnect Drawings (Example Only)
Figure C-3 TIS Display Options Example
GTX 23
P2301
ARINC 429 OUT 2 A
ARINC 429 OUT 2 B
30
28
P4001/5001
GNS 4XX/5XX
50
ARINC IN 2A
46
TIS CONNECT SELECT
51
11
ARINC IN 2B
ANNUNCIATE E
TIS Setup
The GDU 37X will display TIS traffic data from the GTX 23, but one also has the opƟon of displaying TIS
traffic data on a GNS 4XXW/5XXW-series unit.
DirecƟons for setƟng up a GNS 4XXW/5XXW-series unit to display TIS data:
- Following direcƟons in the GNS installaƟon manual, go to the ARINC 429 configuraƟon page.
Configure the ARINC input connected to the GTX to:
o Speed=High
o Format=Garmin GTX 330
NOTES:
1. THE CONNECTIONS ON THIS PAGE ARE OPTIONAL. THE GDU 37X WILL DISPLAY TIS DATA. THESE
CONNECTIONS ENABLE TIS TO BE DISPLAYED ON A GNS 4XXW/5XXW-SERIES UNIT.
2. IF TIS WILL BE DISPLAYED ON A GNS, THE GNS MUST BE CONFIGURED FOR THIS SETUP. PLEASE
SEE THE FOLLOWING CONFIGURATION GUIDANCE.
3. ALL WIRES 24 AWG OR LARGER UNLESS OTHERWISE NOTED.
4. THE GTX 23 REQUIRES THAT ARINC 429 OUTPUT #2 BE USED FOR TIS, BUT ANY UNUSED ARINC
429 INPUT ON THE GNS MAY BE USED.
5. WHEN TIS IS USED ON A GNS, DO NOT CONNECT ANOTHER TRAFFIC SYSTEM TO THE SAME GNS
SERIES UNIT.
6. THE SINGLE WIRE CONNECTED TO THE TIS CONNECT SELECT INPUT OF THE GTX 23 IS OPTIONAL.
THE GNS CAN COMMAND THE GTX TO PUT TIS IN STANDBY MODE. THIS WIRE IS NECESSARY TO
PUT TIS INTO AND BRING IT OUT OF STANDBY MODE.