Filter
Top Products
HP NetRAID-4M Cluster Services Installation Guide Hardware, Drivers and Utilities
8
24. When the update is complete, select the option to exit then press E to exit to DOS.
25. Remove the floppy from the server floppy drive and power the server off.
26. Repeat the previous steps 16 – 25 to update the firmware of the HP NetRAID-4M in
Server B.
Connect the NetRAID-4M SCSI Cables
27. Verify that the HP RackStorage/12 units each have two SCSI Controller cards installed, as
shown below:
28. Change the HP RackStorage/12 unit option switch 1 (top) to the Cluster Mode position
(right), as shown below:
29. Insert disk drives into HP RackStorage/12 units, beginning with the left-most slot.
SCSI Controller Cards