Filter
Top Products
HP NetRAID-4M Cluster Services Installation Guide Hardware, Drivers and Utilities
10
2.3 Set NetRAID-4M BIOS Options
Set Controller Configuration Options
1. Power on Server A. Do not power on Server B at this time.
2. During the boot process, press Ctrl-A at the HP NetRAID-4M configuration prompt.
CAUTION DO NOT allow the server to boot to Windows 2000 Advanced Server at this
point.
The screen will pause for a few or maybe several seconds while the HP NetRAID-4M
detects the disk drives and displays the message:
Waiting for Array Controller #0 to start….|
3. Within the HP NetRAID-4M Controller Configuration Utility, select the SCSISelect
Utility option.
4. Select the Controller Configuration option.
5. Verify that the Write Cache option is set to Disabled.
6. To disable the HP NetRAID-4M BIOS, select Runtime BIOS and press Enter. Use the
arrow key to select Disabled then press Enter. Press ESC to exit this screen and click Yes
to save changes.
Set SCSI Configuration Options
7. Select SCSI Configuration and then select Channel 0. Press Enter.
8. Verify or change the SCSI ID for the server that you are currently working on as follows:
Server A: ID = 7
Server B: ID = 6
9. Change the Clustering option to Enabled and verify that the Domain Validation option
is set to Enabled.