Filter
Top Products
1. Assemble the Control Head Base
Your control head base will have a tilt and swivel mount. See the instructions
below to assemble and mount the control head base.
To assemble a tilt and swivel mount:
1. Insert the mount arms into the base.
Then, hold the mount arms in place
as you turn the base upside down.
2. Insert the swivel ring into the base,
with the countersink holes for the
arm screws facing out.
3. Secure the mount arms with the four
#6 screws provided (Figure 28). Hand
tighten only!
Tilt and SwivelMount
Control HeadBase Assembly
Mount Arms
Base
Arm Screws,
4 #6 x7/16"
Figure28
Countersink
Side Out
Swivel
Ring
21
PiranhaMAX Portable Case Assembly