Filter
Top Products
2. Assemble the Base and Handle
In this procedure, you will install the PiranhaMAX mount and handle to the
base of the portable case.
1. Turn the base upside down. Punch
out the mounting holes labeled “C”
with a hammer and a screwdriver (or
an awl) as shown in the illustration
Punching Holes.
2. Turn the base right side up. Line up
the PiranhaMAX mount with the
holes you punched out in step 1.
3. Using a socket wrench and a Phillips
screwdriver, secure the PiranhaMAX
mount to the base with the four
included 3/4” screws, lock washers,
and nuts. Hand tighten only!
Attaching theMount to the Base
PiranhaMAX Tilt
and Swivel Mount
Base
Figure30
Punching Holes
Figure29
22
PiranhaMAX Portable Case Assembly