Humminbird 4087301 Marine GPS System User Manual


 
2. Route the power cable from the mount
DOWN through the center hole of the
base. Route the transducer jump cable UP
through the base and mount. (Figure 34)
3. Connect the cables to the control head.
The slots for the plugs are keyed to prevent
reverse installation, and insertion should
be easy. Do not to force the connectors
into the control head. (Figure 35)
4. Pull the power cable through the opening
in the long side of the cable well and
insert it into the battery well (see the
illustration Installing the Cables Onto the
Base).
5. Route the transducer jumper cable (see the
illustration Installing the Cables Onto the
Base) out the long side of the cable well
and follow the arrows on the base.
Jumper Cable Well
Installing the Cables Ontothe Base
Transducer
Jumper
Cable
Screws
Power Cable
Figure36
Pulling theCables Throughthe Base
Figure34
Connecting theCables to theControl Head
Figure35
25
PiranhaMAX Portable Case Assembly