Filter
Top Products
4. Route the Cables
In this procedure, you will route the power
and transducer jumper cables on the
underside of the base, and attach the tie-
down straps that will be used to secure
the battery to the base in a later
procedure.
1. Turn the base upside down, then
thread the two included hook and
loop battery tie-down straps from
the bottom of the base up through
each side of the battery well, using
the strap holes (see the illustration
Attaching the Battery Tie-Down
Straps).
Figure33
Attaching theBattery Tie-DownStraps
Battery
tie-down straps
Pivot
Knuckle
Gimbal Knob
Thumbknob
Bolt
Attaching theControl Head tothe Baseand Handle
Gimbal Knob
Rear View Front View
Figure32
24
PiranhaMAX Portable Case Assembly