Filter
Top Products
2. Assemble the other transducer parts as shown (see the illustration
Assembling the Portable Bracket below). Hand tighten only!
NOTE: If youareunable toratchet thetransducerso
that it rests below the water and points straight
down, you can disassemble it and align the beads
with a different number until you reach a position
that allows the proper alignment.
8. Stow the Portable Transducer and Battery Charger
into the Portable Case
1. Load the portable transducer into the carrying compartment (upper zip
opening on the back of the portable case) and close the zipper.
2. Turn the portable case around so that you can access the front, and
load the battery charger into the zip pocket on the left as you face the
front of the portable case.
3. Make sure all the zippers are closed.
Ratchets Placed in Position 2
Bead
Ratchet
Rib
Figure42
Assembling the Portable Bracket
Suction Cup
Portable Transducer
Assembly
Phillips Head
Screw
Washer
Wing Nut
Bolt
Ratchet
Figure41
29
PiranhaMAX Portable Case Assembly