Filter
Top Products
3. Pull the two battery tie-down straps over the top of the battery and
connect both ends of each strap over the top, making sure that the
straps are pulled tight around the battery and that the battery is
seated securely in the battery well.
4. Zip up the back opening.
7. Assemble the Transducer Mounting Bracket
In this procedure you will assemble the portable transducer mounting bracket.
1. Line up the two ratchet pieces at position 1 so that the beads are
aligned with the rib on the transducer. See illustrations.
Transducer Knuckle Positions
Knuckle
Ratchets Placedin Position 1
Rib at
position 1
Beads
Ratchet
Figure40
NOTE: Do NOT connect the power cable to the battery at this time. You should wait
until just before fishing to connect the power cable to the battery.
Installing theBattery Tying Downthe Battery
Figure39
28
PiranhaMAX Portable Case Assembly