Icom MR-1000RTM Fish Finder User Manual


 
BASIC OPERATION
4
8
Checking the installation
Before turning the power ON, be sure all the connec-
tions are complete. The checklist at right may be help-
ful for necessary conrmation.
DChecklist
q The 4 bolts securing the scanner unit must be rmly
tightened.
w Cabling must be securely attached to a mast or
mounting material, and must not interfere with the
rigging.
e Be sure waterproofing procedures are completed
on the system cable.
r The power connections to the battery must be of the
correct polarity.
t Be sure that the plugs at the rear of the display unit
have been connected correctly and securely.
(See p. 24 for details.)
CAUTION: Connect the scanner unit before turning the
power ON. Otherwise the magnetron inside the scanner
unit might be damaged.
Turning power ON/OFF
q Push [POWER]/[ ] to turn the power ON.
The initial screen appears and warming up time is
counted down on the screen.
The magnetron inside the scanner unit warms up for 90 sec.
[POWER]/[]does not function for 2 sec. after
the power is turned OFF.
w When the countdown is completed, the Standby
screen appears.
e Push [TX]/[ ] to start scanning and select
the Plan Position Indicator (PPI) screen.
Targets and heading marker appear.
The screen appears approx. 2 sec. after turning the
power on, when AUTOis selected in the TUNE of the
VIDEO menu.
r Push [POWER]/[ ] to turn the power OFF.
1
(0.25)
T.VECT 6M
0.000NM
NM
CURS
SOG17.7KT
H UP
000.0˚T
HDG253.4˚T
EBL1
EBL2
MOB
VRM1
VRM2
CURS 34˚ 37.72N
135˚ 34.42E
STBY
IR
COMPASS
GPS
1
(0.25)
T.VECT 6M
0.000NM
NM
CURS
SOG17.7KT
H UP
000.0˚T
HDG253.4˚T
EBL1
EBL2
MOB
VRM1
VRM2
CURS 34˚ 37.72N
135˚ 34.42E
IR
COMPASS
GPS
0.45
REV *.*
ROM OK
RAM OK
MR-1000R2_T2.qxd 04.2.24 10:22 Page 8