Filter
Top Products
11
32
SERVICE MAN MENU
■ Service man menu
To open the “SERVICE MAN” menu.
Push [MENU]/[ ] several times to show the
“SERVICE MAN” menu.
■ Select the language
Menu screens can be displayed in 2 different
languages.
Selectable languages; ENGLISH, (CHINESE)
After opening the “SERVICE MAN” menu;
q Push [Ù] to show the present language.
w Push [
Ω≈
] to select desired language, then push
[Ú] to continue the setting.
e Push [MENU]/[ ] to exit the “SERVICE MAN”
menu.
DTIMING ADJ.
•Corrects the distance.
DHDG ADJ.
•Adjusts the electronic heading line adjustment.
DSPD ADJ.
•Enter the pulse rate of the speed sensor.
DRANGE
•
1
⁄8,
1
⁄4,
1
⁄2,
3
⁄4, 1, 1.5, 2, 3, 4, 6, 8, 12, 16, 24, 32, 36,
48* : Choose the selectable screen range.
*MR-1000TII only
DSETUP MEMORY
•The present setting value is displayed by pushing [
≈
],
then select the desired item from “RECALL” and
“SAVE” using with [Ú].
q Push [
≈
] to display “RECALL” and “SAVE”.
w Push [ÙÚ] to select “RECALL” or “SAVE”.
e Push [
≈
].
•“SURE ?” is displayed.
r Push [
≈
] to perform.
t Push [
Ω
]
to cancel
.
•When recall is performed without saving a setup, it
will become an initial value at the time of factory
shipments.
DOther readouts
•OUTPUT VOLTAGE
: Shows the voltage level for the
scanner unit from the display unit.
•HV (High voltage): Shows the voltage level in the
high-voltage unit in the scanner
unit.
•MONITOR : Shows the voltage level for
checking the receiver unit opera-
tion.
•HEATER :Shows the heater current.
•MG :Shows the current level for the
Magnetron.
•TX TIME :Shows the total transmitted time.
SERVICE MAN
SPD ADJ.
HDG ADJ. 0.0
˚
HV
SETUP MEMORY RECALL
RANGE
24000 MONITOR
HEATER
5731.0H
TX TIME
30.0
OUTPUT
ENGLISH
VOLTAGE
SAVE MG
340
75
3.0
0.55
TIMING ADJ.
1/8 3/4 2 6
1/4 1 3 8
1/2 1.5 4 12
16
24
32
36
48
CAUTION: The SERVICE MAN MENU is available
for service purposes only. DO NOT change any set-
ting on the menu, otherwise the equipment may not
operate at it’s original performance.
MR-1000R2_T2.qxd 04.2.24 10:22 Page 32