Kenwood TH-D7E Marine Radio User Manual


 
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
28
CLEARING A MEMORY CHANNEL
Use the following procedure to clear an individual
memory channel. Full Reset {page 32} is a quick way to
clear all memory channels.
1 Recall the desired memory channel.
2 Switch OFF the power to the transceiver.
3 Press [MR]+ POWER ON.
A confirmation message appears.
To quit clearing the memory channel, press [ESC].
4 Press [MR] again.
The contents of the memory channel are erased.
Note: If you have recalled a memory channel on the non-current band (A
or B), you cannot select the same channel on the current band to clear.
RECALLING A MEMORY CHANNEL
1 Select the desired band.
2 Press [MR] to enter Memory Recall mode.
The memory channel used last is recalled.
3 Press [UP]/ [DWN] to select the desired memory
channel.
You cannot recall an empty memory channel.
To restore VFO mode, press [VFO].
You can also recall a memory channel by direct entry
from the keypad. In Memory Recall mode press [ENT],
then enter the channel number. To recall channel 3, for
example, press [ENT], [0], [0], [3].
Note:
When you recall an odd-split memory channel, “+” and “–” appear on
the display. Press [REV] to display the transmit frequency.
After recalling a memory channel, you may program data such as
Tone or CTCSS. These settings, however, are cleared once you
select another channel or the VFO mode. To permanently store the
data, overwrite the channel contents {page 27}.
TH-D7 E 26 Memory Channels 98.12.4, 0:11 PM28