Kenwood TH-D7E Marine Radio User Manual


 
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
71
PROGRAMMING A GROUP CODE
Using a group code relieves you from receiving
unwanted packets. The APRS on this transceiver
supports the following three types of group codes.
All calls:
Program a 6-digit code that always starts with AP. You
will receive all APRS packets which include AP in group
codes. It does not matter whether or not the subsequent
4 digits match. The default on this transceiver is
APK001; K001 stands for KENWOOD Ver.1.
Note: APRS packets, which are generated via various methods, include
various codes instead of group codes. Using “All calls” allows you to
receive packets which include the following codes.
Special:
Enter “SPCL”. You will receive only APRS packets that
include SPCL as a group code. This code is generally
programmed by all stations at a special event.
Alternate net:
Program any other code with a maximum of 6 digits.
You will receive only APRS packets that include the
exact same code. In order to reject other packets, this
code should not include characters specified by the
above two types.
SPGMYSTSQQCNOCAEB
LLANRWYKSLIAMDILCPS
Note: Menu 2–A allows you to enter up to 9 digits (not 6 digits) because
of possible future enhancement of the group code system.
1 Press [MENU] to enter Menu mode.
2 Press [2], [A] to select “2–A (UNPROTOCOL)”.
The display for entering characters appears; the first
digit blinks. The default is APK001 (All calls).
3 Press [UP]/ [DWN] to select a character.
You can enter 0 to 9, A to Z, and –.
4 Press [OK].
The cursor moves to the next digit.
5 Repeat steps 3 and 4 to enter up to 9 digits.
Pressing [OK] after selecting the 9th digit completes the
programming.
To complete programming after entering less than
9 digits, press [OK] twice.
Each press of [ESC] causes the cursor to move
backward.
Pressing [A/B] deletes the digit at which the cursor is
blinking.
6 Press [MENU] to exit Menu mode.
You can also use the keypad to enter alphanumeric
characters in step 3. For example, each press of [TNC]
switches entry as A, B, C, then 2. Press [ENT] to enter
–.
STA
CON
96
BCON
DUP
9
7
5
TH-D7 E 61 APRS 98.12.4, 0:13 PM71