Kenwood TH-D7E Marine Radio User Manual


 
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
48
ADJUSTING VOLUME BALANCE
While simultaneously receiving on 2 bands, you may
sometimes feel that audio output on either band is too
noisy. You can adjust the volume on the noisy band.
1 Press [BAL].
The balance scale appears with a blinking cursor.
2 Press [UP]/ [DWN] to change the setting.
3 Press [OK] to complete the setting.
LAMP FUNCTION
You can illuminate the transceiver display and keypad by
pressing [LAMP]. Approximately 5 seconds after
releasing [LAMP], the light goes OFF if no other key is
pressed. Pressing any key other than [LAMP] while the
display is lit restarts the 5 second timer; pressing
[LAMP] turns OFF the light immediately.
To latch the light ON, press [F], [LAMP]. The light
remains ON until you press [F], [LAMP] again.
Max: Maximum
Mute: Muted
Att: Attenuated
Band A Max Max Max Att Mute
Band B Mute Att Max Max Max
ADJUSTING DISPLAY CONTRAST
The display visibility changes depending on ambient
conditions, for example between daytime and nighttime.
When you find the display is not clear, use this function
to select the optimum display contrast.
Access Menu 1–1–2 (CONTRAST) and select the
contrast from 16 levels. The default is level 8.
BLANKING A BAND DISPLAY
If you have no plans to use band A or B, quit frequency
display on the unused band. This saves power
consumption and makes it simpler to read the
information you need.
1 Press [A/B] to select band A or B.
2 Press [DUAL] to switch the function ON (or OFF).
The non-current band will be blanked.
TH-D7 E 45 Auxiliary Functions 98.12.4, 0:12 PM48