Filter
Top Products
TK-7100
5
REALIGNMENT
1. Modes
User mode PC mode PC programming mode
Clone mode
PC test mode
PC tuning mode
Self programming mode
Mode Function
User mode For normal use.
PC mode Used for communication between the
radio and PC (IBM compatible).
PC programming Used to read and write frequency data
mode and other features to and from the radio.
PC test mode Used to check the radio using the PC.
This feature is included in the FPU.
PC tuning mode Used to tune the radio using the PC.
Clone mode Used to transfer programming data from
one radio to another.
Self programming You can program the frequency, signalling
mode and other functions using only the radio.
2. How to Enter Each Mode
Mode Operation
User mode Power ON
PC mode Received commands from PC
Clone mode
[CH DOWN]+Power ON (Two seconds)
Self programming mode [MON]+Powr ON (Two seconds)
3. PC Mode
3-1. Preface
The TK-7100 transceiver is programmed using a personal
computer, a programming interface (KPG-46) and program-
ming software (KPG-80D).
The programming software can be used with an IBM PC
or compatible. Figure 1 shows the setup of an IBM PC for
programming.
3-2. Connection Procedure
1. Connect the TK-7100 to the personal computer with the
interface cable.
2. When the Power is switched on, user mode can be en-
tered immediately. When the PC sends a command, the
radio enters PC mode.
When data is transmitted from transceiver, the TX indica-
tor blink.
When data is received by the transceiver, the BUSY indi-
cator blink.
In the PC mode, “ PC ” is displayed on the LCD.
3-3. KPG-46 Description
(PC programming interface cable : Option)
The KPG-46 is required to interface the TK-7100 to the
computer. It has a circuit in its D-subconnector (25-pin) case
that converts the RS-232C logic level to the TTL level.
The KPG-46 connects the modular microphone jack of the
TK-7100 to the computers RS-232C serial port.
3-4. Programming Software Description
KPG-80D is the programming software for TK-7100 sup-
plied on three 3.5” floppy diskettes. This software runs un-
der Windows 98, ME, Windows 2000 or XP on an IBM-PC or
compatible machine.
The data can be input to or read from TK-7100 and edited
on the screen. The programmed or edited data can be
printed out. It is also possible to tune the transceiver.
4. Clone Mode
Programming data can be transferred from one radio to
another by connecting them via their modular microphone
jacks. The operation is as follows (the transmit radio is the
master and the receive radio is the slave).
Note :
Clone mode should be enabled.
1. Turn the master TK-7100 power ON with the [CH DOWN]
key held down (2 seconds), “ CLONE ” is displayed on
the LCD.
2. Power on the slave TK-7100.
3. Connect the cloning cable (No. E30-3382-05) to the modu-
lar microphone jacks on the master and slave.
4. Press the [MON] key on the master TK-7100 transceiver.
The data of the master is sent to the slave. While the
master is sending data, [TX] icon blinked. While the slave
is receiving the data, “ PC ” is displayed and [BUSY] icon
blinked. When cloning of data is completed, the master
displays “END”, and the master [TX] icon turned off, and
the slave automatically operates in the User mode. The
slave can then be operated by the same program as the
master.
5. The other slave can be continuously cloned. Carry out the
operation in step 2 to 4.
Fig. 1
IBM-PC
KPG-46
TK-7100
KPG-80D