Filter
Top Products
SECTION THREE: Installing and wiring the 2201 or 2301
958 Installation Manual, Rev. A1 Page 13
Figure 8: Recommended separation distances between antennas
Mounting and wiring the 2201
To mount the 2201 onto a deck or any other flat surface:
1. Using the three screws and washers provided, mount the 2201 onto the flat surface
using three holes on a 1.75-inch diameter circle (see Figure9 below).
Figure 9: Mounting the 2201 on a flat surface (viewed from below)
Connector receptacle with 7
male contacts. Mating:
Switchcraft EN3C7FC or
equivalent.
3x 3/16” - 32UNF - 2B x .48
deep. Mounting holes
equally spaced around a
1.75” diameter circle.
1.00 -14UNS-2Bx 1.00 deep.
φ
φφ
φ1.750