Filter
Top Products
SECTION THREE: Installing and wiring the 2201 or 2301
Page 14 958 Installation Manual, Rev. A1
2. Make sure the 2201 has enough clearance for you to easily connect the cable. For
example, mount the 2201 on the edge of the deck, or drill a small hole in the deck
or other surface to allow the cable to pass through.
To mount the 2201 on a standard antenna mount:
1. Using the 1”x 14 marine-industry standard UNS thread mounting, install the base
of the 2201 onto a standard antenna mount. Do not overtighten or you may
damage the housing!
Figure 10: Using a standard antenna mount
2. To avoid stressing the 2201’s connector with the weight of the cable, use a tie-wrap
or similar near the 2201 to hold the cable’s weight.
3. Plug the 2201 end of the cable into the 2201, and the 958 end into the connector
labelled “GPS.” Coil any extra cable away from the 2201. Don’t pinch the cable or
make any sharp bends. Don’t run the cable where it interferes with any controls.
3.79” (96mm)
4.50” (114mm)