Filter
Top Products
19
PRO PLUS 3 OPERATING MANUAL
© 2002 Design, 2012 Doc. No. 12-5332-r01 (11/19/12)
Fig. 42 - Set DIVE OP MODE
Fig. 43 - HISTORY 1
Fig. 44 - HISTORY 2
Fig. 45 - HISTORY 3
Set Dive Operating Mode, information includes (Fig. 42):
> Graphics OP and MODE.
> Graphic NOR (or GAU), flashing.
• A (< 2 sec) to toggle between NOR and GAU.
• S (< 2 sec) to save the setting and access that mode's Surface Main screen.
• S (2 sec) to step back to Set Mode Lead-in.
------------------------------------------------------------------------------------------------------------------------------------------------------
HISTORY MODE (NORM/GAUG)
History is a summary of basic data recorded during all NORM and GAUG dives conducted.
History 1, information includes (Fig. 43):
> HIST icon with graphic tot (= total).
> Total number dives recorded (up to 9999) with # icon, 0 if no dive yet.
> Total hours of Elapsed Dive Time recorded (up to 9999 hours) with EDT icon.
• A (< 2 sec) to step forward to Serial Number.
• S (< 2 sec) to access History 2.
History 2, information includes (Fig. 44):
> HIST icon with graphic EVER.
> Max Depth ever recorded with MAX and FT (or M) icons.
> Longest Elapsed Dive Time ever recorded during a single dive (up to 599 min) with EDT and min icons.
• S (< 2 sec) to access History 2.
• S (2 sec) to step back to History 1.
History 3, information includes (Fig. 45):
> HIST icon with graphic EVEr.
> Lowest Temperature ever recorded with graphic F (or C).
> Graphic SEA, or EL2 to EL7, highest Altitude at which a dive was ever conducted
• S (< 2 sec) to revert to History 1.
• S (2 sec) to step back to History 2.
SERIAL NUMBER
Information displayed on this screen should be recorded and kept with your sales receipt, it will be required in the event that your
Pro Plus 3 requires factory service.
Serial Number, information includes (Fig. 46):
> Graphic SN with the factory programmed serial number (up to 199999).
> Graphic R1A (or higher), indicating the revision level of the firmware (Pro Plus 3's current operating software).
• A (< 2 sec) to revert to Surface Main.
• S (< 2 sec) to access Clear (Reset), NORM only.
Refer to page 22.
Fig. 46 - SN