Filter
Top Products
Page 135 Advanced HotSync® Operations
6. Click OK.
The HotSync Manager is now communicating with the simulated port
defined for infrared communication. This means that you cannot use
your HotSync cradle/cable again until you reconfigure the HotSync
Manager to communicate with the port defined for cradle/cable
synchronization.
To configure HotSync Manager for infrared communication
on a Macintosh:
1. Double-click the HotSync Manager icon in the Palm folder.
2. In the HotSync Controls tab, select Enabled.
3. Click the Serial Port Settings tab.
4. Under Check for handheld connection using, select Local Setup.
5. Under Local Setup, select Infrared Port from the Port pop-up
menu.
6. Close the HotSync Software Setup window.