Filter
Top Products
Page 11 Introduction to Your Palm™ m100 Series Handheld
To connect the HotSync cradle/cable:
1. Turn off your computer.
2. Plug the HotSync cradle/cable into a serial (COM) port on your
computer.
Note:
Your HotSync cradle/cable requires a dedicated port. It
cannot share a port with an internal modem or other
device. If you are unsure of the exact location of the serial
port, refer to the manual supplied with your computer.
If your computer does not have a dedicated serial port available, or the
cradle/cable does not fit your computer, you can order the following
HotSync cradle/cable adapters from:
http://www.palm. com/support/m100/extras
Shown with a
HotSync cradle.
Some models use
a cable in place
of the cradle.
Macintosh serial 25-pin serial USB