Filter
Top Products
Features and functions
43
NOTE:
The beeps and the flashing digital speedome-
ter display also indicate the activation of the
cruise assist. (See page 44 for more informa-
tion.)
To activate the no-wake mode:
NOTE:
The no-wake mode cannot be activated im-
mediately after starting the engine. After start-
ing the engine, wait for 5 seconds or more
before activating the mode.
(1) Release the throttle lever.
(2) Check that the shift lever is in the forward
position.
NOTE:
The no-wake mode cannot be activated when
the shift lever is in the reverse position.
(3) Push and hold the “NO-WAKE MODE”
switch. When the no-wake mode is acti-
vated, the beeper sounds three times
quickly and “5” (when miles are selected)
or “8” (when kilometers are selected)
starts flashing in the digital speedometer
display. Keep the throttle lever in the idle
position when the no-wake mode is acti-
vated.
NOTE:
The digital speedometer display flashes con-
tinually while the no-wake mode is activated.
To deactivate the no-wake mode:
Perform one of the following procedures. The
beeper sounds two times quickly and the dig-
ital speedometer display stops flashing when
the no-wake mode is deactivated.
● Push the “NO-WAKE MODE” switch.
● Squeeze the throttle lever.
Number
of beeps
No-wake mode oper-
ation
Digital
speedome-
ter display
Activated
Starts
flashing
Deactivated
Stops
flashing
1 Shift lever
2 Forward position
1
2
1 “NO-WAKE MODE” switch
1
UF1W10E0.book Page 43 Monday, November 26, 2007 3:57 PM