Filter
Top Products
Features and functions
46
ponents for help and convenience in operat-
ing the watercraft.
CAUTION:
ECJ00072
Do not run the engine for more than 15
seconds without supplying water or over
4000 r/min when checking the operation of
the meter on land, otherwise the engine
could overheat.
NOTE:
● When the multifunction information center
starts operating, the analog speedome-
ter/tachometer makes one sweep, all dis-
plays light up for 2 seconds, and then the
meter starts to operate normally.
● The multifunction information center will
continue to operate for 25 seconds after the
engine stops.
EJU34930
Analog speedometer/tachometer and indi-
cator lights
This watercraft is equipped with the following
meter and indicator lights.
EJU36790
Analog speedometer/tachometer
The analog speedometer/tachometer can be
used as a speedometer or a tachometer.
To switch between the speedometer and the
tachometer functions, push the “Speed/RPM”
button for at least 1 second when the multi-
function information center is operating.
The “SPEED” indicator light comes on when
the analog speedometer is selected. The
1 Analog speedometer/tachometer and indi-
cator lights
2 Left multifunction display and operation but-
tons
3 Right multifunction display and operation
buttons (for FX Cruiser SHO)
1 Analog speedometer/tachometer
2 “SPEED” indicator light
3 “WARNING” indicator light
4 “RPM” indicator light
5 “UNLOCK” indicator light
6 “L-MODE” indicator light
UF1W10E0.book Page 46 Monday, November 26, 2007 3:57 PM