Filter
Top Products
Maintenance and care
87
water passages by alternately squeezing
and releasing the throttle lever for 10 to
15 seconds.
(8) Stop the engine.
(9) Remove the garden hose adapter and in-
stall the flushing hose connector cap.
EJU36901
Lubrication
WARNING
EWJ00260
Do not spray flammable rust inhibitor
products on engine surfaces while the en-
gine is hot. The sprayed substance or pro-
pellants could catch fire.
(1) Lubricate all cables such as the throttle
and steering cables.
NOTE:
Use a Yamaha Power Cable Luber and
Yamaha Lube-Zall to pressure-lubricate the
cables and purge out any moisture between
the inner and outer cables.
(2) Lubricate the areas of the watercraft
specified in “Lubrication points” on page
98.
EJU33661
Fuel system
WARNING
EWJ00281
GASOLINE AND ITS VAPORS ARE HIGH-
LY FLAMMABLE AND EXPLOSIVE!
● Do not smoke when refueling, and keep
away from sparks, flames, and other
sources of ignition.
● Stop the engine before refueling.
● Refuel in a well-ventilated area with the
watercraft in a horizontal position.
● Do not stand or sit on the watercraft
while refueling.
● Take care not to spill gasoline. If gaso-
line spills, wipe it up immediately with
dry rags. Always properly dispose of
gasoline-soaked rags.
● Avoid overfilling the fuel tank. Stop fill-
ing when the fuel level reaches approxi-
mately 50 mm (2 in) from the top of the
fuel tank. Fuel expands as it warms up
and could overflow if the fuel tank has
been overfilled. If temporarily leaving
the watercraft with a full fuel tank, do not
leave it in direct sunlight. Leave it in a
well-ventilated area with the watercraft
in a horizontal position.
● Tighten the fuel tank filler cap securely
after refueling.
● If you should swallow some gasoline, in-
hale a lot of gasoline vapor, or get gaso-
line in your eyes, get immediate medical
attention.
● If any gasoline spills on your skin or
clothing, immediately wash the affected
area with soap and water and change
your clothes.
Top off the fuel tank with fresh gasoline and
add one ounce of Yamaha Fuel Stabilizer and
Conditioner per each gallon of fuel.
EJU33680
Battery
If the watercraft will not be used for more than
a month, remove the battery from the water-
craft and store it in a cool, dry place.
(1) Disconnect the negative (–) battery lead
first, then the positive (+) battery lead and
breather hose, and then remove the bat-
tery from the watercraft.
(2) Clean the battery casing using fresh wa-
ter.
(3) If the battery terminals are dirty or corrod-
ed, clean them with a wire brush.
(4) Fully charge the battery.
(5) Apply Yamaha Marine Grease or
Yamaha Grease A to the battery termi-
UF1W10E0.book Page 87 Monday, November 26, 2007 3:57 PM