Filter
Top Products
Operation
70
come entangled in moving parts, result-
ing in severe injury or drowning.
● Stop the engine and remove the clip
from the engine shut-off switch before
removing any debris or weeds, which
may have collected around the jet in-
take.
EJU32660
Engine shut-off cord
Check that the engine shut-off cord is not
frayed or broken. If the cord is damaged, re-
place it; never try to repair it or tie it together.
EJU32670
Switches
CAUTION:
ECJ00410
Do not run the engine for more than 15
seconds when checking the switches on
land without supplying water, otherwise
the engine could overheat.
Check the start switch, the engine stop
switch, and the engine shut-off switch for
proper operation.
Push the start switch to start the engine. As
soon as the engine starts running, push the
engine stop switch to verify that the engine
stops immediately. Restart the engine, and
then pull the engine shut-off cord to remove
the clip from the engine shut-off switch to ver-
ify that the engine stops immediately. (See
pages 33 to 34 for information on proper op-
eration of the start switch, the engine stop
switch, and the engine shut-off switch.)
EJU36890
Cooling water pilot outlets
Check that water comes out from the port
(left) cooling water pilot outlets while the en-
1 Start switch
2 Engine stop switch
3 Engine shut-off switch
4 Clip
5 Engine shut-off cord
4
1
3
5
2
UF1W10E0.book Page 70 Monday, November 26, 2007 3:57 PM