5: Commands and Levels
packing (tunnel-packing:1) level commands
Sets to default packing mode, which is "Disable"
Removes the send character for packing mode.
Restores the default threshold.
Restores the default packing mode timeout.
Returns to the tunnel level.
Removes the trailing character for packing mode.
Disables packing. Data is sent to the network when received.
packing mode send character
Sets packing mode to accumulate data and transmit it upon re-
ceiving the
configured send character on the line (serial port).
Sets packing mode to accumulate data and transmit it after a
specified
amount of time (timeout).
Sets the send character for packing mode.
The character may be input as text, control, decimal, or hex.
A control character has the form <control>C.
A decimal value character has the form \99.
A hex value character has the form 0xFF.
Displays the current configuration.
Displays the last 20 commands entered during the current CLI
session.
Sets the threshold (byte count). If the queued data reaches this
threshold
then the data will be sent.
<bytes> = number of bytes in the threshold.
Sets the timeout value for packing mode in milliseconds.
<milliseconds> = timeout value, in milliseconds.
trailing character <control>
Sets the trailing character for packing mode.
The character may be input as text, control, decimal, or hex.
A control character has the form <control>C.
A decimal value character has the form \99.
A hex value character has the form 0xFF.
Stores the current configuration in permanent memory.
password (tunnel-accept-password:3) level commands
Exits to the next higher level.
Removes the password so connections will be accepted unchal-
lenged.
Sets the password required on the network side of the tunnel to
begin
Inhibits any prompting for password on the network side of the
tunnel.
Sets up so a user on the network side of the tunnel will be
prompted for
Shows the current configuration.
Displays the last 20 commands entered during the current CLI
session.
PremierWave EN Command Reference 195
