A SERVICE OF

logo

Open as PDF
next previous
5: Commands and Levels
auto show statistics
show connection statistics
clear counters
Zeros all tunnel counters
clrscrn
Clears the screen.
connect
Enters the connect level for this tunnel.
disconnect
Enters the disconnect level for this tunnel.
exit
Exits to the enable level.
line <line>
Enters the line level.
<line> = number of the line (serial port) to be configured.
modem
Enters the modem level for this tunnel.
no clear counters
Unzeros all tunnel counters
packing
Enters the packing level for this tunnel.
serial
Enters the serial level for this tunnel.
show history
Displays the last 20 commands entered during the current CLI
session.
show statistics
show connection statistics
terminal <line>
Enters the configure-terminal level.
<line> = number of the terminal line (serial port) to be configured.
terminal network
Enters the configure-terminal level for the network.
tunnel <line>
Enters the tunnel level.
<line> = number of the tunnel line (serial port) to be configured.
write
Stores the current configuration in permanent memory.
vip (config-vip) level commands
auto show counters
Displays VIP counters continuously.
auto show status
Displays VIP status continuously.
clear counters
Sets the VIP counters to zero.
clrscrn
Clears the screen.
exit
Exits to the configuration level.
no clear counters
Restores the VIP counters to the aggregate values.
show
Displays the current configuration.
show counters
Displays the VIP counters.
show history
Displays the last 20 commands entered during the current CLI
session.
show status
Displays the VIP status.
state disable
Disables use of Virtual IP (VIP) addresses.
state enable
Enables use of Virtual IP (VIP) addresses.
write
Stores the current configuration in permanent memory.
wep (config-profile-security-wep:test1) level commands
apply wlan
Try out WLAN settings without saving them to Flash.
If the settings do not work, when you reboot the device,
it will still have the original settings.
authentication open
Sets the type of authentication to open.
authentication shared
Sets the type of authentication to shared.
clrscrn
Clears the screen.
default authentication
Restores the authentication type to the default value (open).
default key size
Restores the key size to the default value (40 bits).
default tx key index
Restores the tx key index to the default value (1).
PremierWave EN Command Reference 207