A SERVICE OF

logo

Getting Set Up
2
User Manual
2-25
Turning on the printer
After you have connected the interface cables, you are ready to connect the
power cord and turn on the printer. If you need to turn the printer off, wait
until the display shows Ready or the printer’s name before powering it
down.
Caution
To avoid damaging the printer, make sure that the voltage
select switch is set to match the AC line voltage for your
location and that the power switch is in the off position before
connecting the power cord.
If you move the printer to a location that uses a line voltage other than the
printer’s current setting, refer to “Changing line voltage” on page 5-41 for
information on changing the line voltage selection switch.
968
2-
03
115
Parallel
Service
port
DIP
AUX
Feeder
PHASER 350
Ethernet®
SCSI Disk
115