Chapter 25 IP Source Guard
GS2210 Series User’s Guide
215
Figure 151 Advanced Application > IP Source Guard > ARP Inspection
The following table describes the labels in this screen.
25.7 ARP Inspection VLAN Status
Use this screen to look at various statistics about ARP packets in each VLAN. To open this screen,
click Advanced Application > IP Source Guard > ARP Inspection > VLAN Status.
Table 95 Advanced Application > IP Source Guard > ARP Inspection
LABEL DESCRIPTION
Total number of
filters
This field displays the current number of MAC address filters that were created because
the Switch identified unauthorized ARP packets.
Index This field displays a sequential number for each MAC address filter.
MAC Address This field displays the source MAC address in the MAC address filter.
VID This field displays the source VLAN ID in the MAC address filter.
Port This field displays the source port of the discarded ARP packet.
Expiry (sec) This field displays how long (in seconds) the MAC address filter remains in the Switch.
You can also delete the record manually (Delete).
Reason This field displays the reason the ARP packet was discarded.
MAC+VLAN: The MAC address and VLAN ID were not in the binding table.
IP: The MAC address and VLAN ID were in the binding table, but the IP address was
not valid.
Port: The MAC address, VLAN ID, and IP address were in the binding table, but the port
number was not valid.
Delete Select this, and click Delete to remove the specified entry.
Cancel Click this to clear the Delete check boxes above.
Change Pages Click Previous or Next to show the previous/next screen if all status information
cannot be seen in one screen.
