Filter
Top Products
1101 and 1102 Secure Device Servers
724-746-5500 | blackbox.com
28
Before proceeding with further serial port configuration, connect the ports to the serial devices they will be controlling, and make sure they have
matching settings.
NOTE: The serial ports are all set at the factory to RS-232: 9600 baud, no parity, 8 data bits, 1 stop bit, and Console server Mode. You can
change the baud rate to 2400–230400 baud using the management console. You can configure lower baud rates (50, 75, 110, 134,
150, 200, 300, 600, 1200, 1800 baud) from the command line. Refer to Chapter 14— Basic Configuration (Linux Commands).
5.1.2 Console Server Mode
Select Console Server Mode to enable remote management access to the serial console that is attached to this serial port:
Figure 5-4. Console Server settings screen.
Logging Level: This specifies the level of information to be logged and monitored (referto Chapter 7— Alerts and Logging).
Telnet: When the Telnet service is enabled on the console server, a Telnet client on a User or Administrator’s computer can connect to a serial device
attached to this serial port on the console server. The Telnet communications are unencrypted, so this protocol is generally recommended only for
local connections.
With Win2000/XP/NT you can run telnet from the command prompt (cmd.exe). Vista and Windows 7 include a Telnet client and server, but they are
not enabled by default. To enable Telnet:
• Log in as Admin and go to Start/Control Panel/Programs and Features.
• Select Turn Windows features on or off, check the Telnet Client, and click OK.