Bushnell 36-1100 Marine GPS System User Manual


  Open as PDF
of 60
 
17
2. Select Display (Fig. 4) and press OK to conrm.


Press the navigation key to the right to increase
 
contrast as required.
Using the ONIX 110 in Simulation Mode
In normal or navigation mode, the ONIX 110 tracks its
position through satellite information. In simulation
mode, the device stops acquiring data from the
        
simulation mode to look up maps, to adjust system
settings, and to conserve battery consumption.
There are two dierent ways to switch to
simulation mode:
To switch to simulation mode from the satellite page:
1. Press the Menu
(Fig. 5).
2. Use the navigation keys to select GPS O and
press OK to conrm. The device stops acquiring
satellite information and enters simulation mode.
3. To return to navigation mode, repeat steps
1 and 2, and select GPS On to resume satellite
navigation.
To switch between simulation and navigation mode
from any page:
1. Press the Menu twice button to display the

2. Use the navigation keys to select User Settings
(Fig. 6) and press OK.
3. Under the Set 1 tab, use the navigation keys to
highlight Navigation Mode option and press OK.
       Simulation
Fig. 5
Fig. 6
Fig. 7
 previous next