Filter
Top Products
Adding a controller
1. Select a controller from the list, or select an embedded controller.
The Controllers drop-down menu is enabled.
2. Click Controllers → New Controller.
The Controller Configuration window is displayed.
3. Under Controller Selection Criteria, select from the following options:
Select the
controller
located in slot
Type the slot number of the controller.
Select any
controller with
<exactly,
atleast>
<number of>
disks attached
Set a rule to select any controller which matches exactly, or at least the
number of disks you have selected.
Select all
remaining
controllers in
the system
regardless of
configuration
Set a rule to select all remaining controllers in the system regardless of
configuration.
4. Under Variable Matching Criteria, you can set a rule to apply this configuration only if it matches
certain criteria that you select. Select Apply this configuration only when variable to enable the rule
setting options.
5. Click OK.
Editing a controller
To edit a controller, select the controller and click Controllers → Edit Controller. On the Controller
Configuration window, you can make changes to your controller.
Deleting a controller
1. Select the controller and click Controllers → Delete Controller.
A warning message that all the attached arrays and disks are deleted is displayed.
2. Click Yes to delete or No to cancel.
NOTE: On a server, you require at least one controller. If there is only one controller and you
delete it, then a message that the default controller was inserted because the last controller was
deleted is displayed.
23