Filter
Top Products
131
Section 8: System & GPS Setup
Alarms
This unit has three GPS alarms: Arrival Alarm, Off Course Alarm and
Anchor Alarm — the only one of the three set to Off by default.
You can set an arrival alarm to flash a warning message and sound a
tone when you cross a preset distance from a waypoint. For example, if
you have the arrival alarm set to .1 mile, the alarm will flash a mes-
sage when you come within .1 mile of your destination.
The off course alarm warns you when your track drifts too far to the
right or left of the course line to your destination. For example, if the
alarm is set to .1 mile, then the alarm flashes a message if you drift .1
miles or more to the right or left of the course line.
The anchor alarm is triggered when you drift outside of a preset radius.
If you are anchored and your boat moves more than .1 miles, the alarm
will flash a message and sound a tone.
Alarms command (left). Alarm menu (right).
To change alarm settings:
1. Press
MENU|MENU|↓ to ALARMS|ENT|ENT.
2. Scroll ↓ ↑ to select the desired category, then press
ENT to turn on
(check) or turn off (uncheck) the desired alarm.
3. To change distance settings, select the desired alarm, then press
→|
ENT to activate the distance dialog box. Press ↑ ↓ to change the first
character, then press → to the next character and repeat until you are
satisfied with the distance setting. If you want to enable the other
alarms, repeat steps 2 and 3.
4. Press
EXIT repeatedly to get back to the main page display.