Filter
Top Products
1-29
4. To access the main configuration menu, select the applicable device
revision. The Online menu for the simulated device is displayed. You can
now use the HART Communicator as if it were connected to the selected
device, and perform any online task.
If you are unsure of the device revision, connect the HART Communicator
to the device and determine its device revision level. This information is
most commonly accessed from Online menu>Device Setup>Detailed
Setup>Device Information. For more information, see your device-specific
manual.
SAVING A CONNECTED DEVICE CONFIGURATION
Selecting the option from any Online menu allows you to save a
configuration transmitted from a connected device to a permanent storage
location.
To save, change, and send a stored configuration:
1. Select .
2. Enter a storage location (Memory Module or data pack).
3. Enter a Name and configuration Data Type. Name defaults to the online
device Tag, and the Data Type defaults to Standard with all editable
variables marked.
NOTE: Saved configurations have to be “Full” for storing in your PC in AMS
software.
Warnings appear if there is not enough memory to store the transmitted
configuration or if there is no list of configurable variables with Data Type
set to standard.
The key disappears until you change any configuration data.
4. To change the configuration data, go into the Device Setup menu options
and change the required data. For example, if the Tag needs to be
changed, start with the Device Setup menu and go into the Basic Setup
menu options, open Tag, and change the data.
Press to load the changed data, then press to send your
changes to the connected device.
5. After each data configuration is sent, the function key appears. You
have the option to save the individual variable or continue to change all of
the variables and save them all at once.
SAVE
SAVE
SAVE
ENTER
SEND
SAVE