Filter
Top Products
1-39
Installing and Removing the Data Pack 100
Refer to Figure 1-43, Figure 1-44, and Figure 1-45.
Use the following steps to install or remove the data pack:
FIGURE 1-45. Data Pack 100 Installation and Removal.
To Install the data pack:
1. Remove the battery pack from the Communicator. Next, either remove the
Memory Module or leave it assembled to the Communicator.
2.The data pack is keyed to prevent incorrect installation. When the
Communicator is facing down, insert the data pack with the part number
label facing down; the hinge of the handle will be onthe left. Press firmly in
place with your fingers.
To remove the data pack:
1. Insert the flat edge of a small screwdriver under the outside edge of the
handle. Lift the handle to disconnect the data pack from its connector.
2. Raise the handle and pull the data pack out of the Memory Module.