Filter
Top Products
3. PLOTTER OPERATION
3-49
Restarting navigation
When you steer to avoid an obstacle or the vessel drifts, you may go off your
intended course, as in Line 1 in the figure below. Also, if you don’t need to return
to the original course, you can go directly to the next waypoint, as in Line 2 in
the figure below. In these cases, use the restart navigation function to restart
navigation.
Original course
Obstacle
Line 1
Line 2
Example of when to restart navigation
1. Press the [MENU] key to open the menu.
2. Press the WAYPOINTS/ROUTES soft key.
3. Press the LOG soft key.
Estimated Time of Arrival at destination
Passed waypoint (gray characters)
TO Waypoint (WPT name in reverse video)
▲
LOG
RE-
START
STOP
RVRSE
SPEED
COORD
TYPE
ETA 23:59 30. APR
02
90.0°
2.86nm
322.6°
3.08nm
75.2°
4.99nm
152.5°
19.87nm
LEG
01
48°18.290'N
123°14.286'W
007WPT
48°17.341'N
123°10.232'W
005WPT
03
48°20.261'N
123°11.658'W
003WPT
04
48°19.862'N
123°04.190'W
006WPT
02
Replaces triangle
when selecting a
route leg.
Replaced by
"FOLLOW LEG"
when selecting
a route leg.
Log display
4. Use the trackball to select a waypoint or a route leg. When a route leg is
selected the single arrow cursor is replaced by double arrows.
5. Press the RESTART soft key or FOLLOW LEG soft key in case of route leg.
Note: Navigation may be restarted from the plotter display, with the
RESTART key, when a single quick point (QP<01>) is selected for
navigation.
6. Press the [MENU] key to close the menu.