Filter
Top Products
2. RADAR OPERATION
2-15
EBL
VRM
EBL1
ON
VRM2
ON
359.9 ˚R
11.70
nm
+
EBL1
(Dotted line)
EBL2
(Dashed line)
EBL2 bearing
Active marker is highlighted.
EBL1 bearing
VRM1
ON
OFFSET
EBL2
ON
EBL1
330.1°R
VRM1
-.---nm
EBL2
234.1˚R
VRM2
-.---nm
12/
H-UP
3nm
LP
319. 9
°M
How to measure bearing with the EBL
4. You may hide the EBL/VRM soft keys by pressing the [EBL/VRM] key.
Note: The bearing to a target may be shown relative to own ship’s heading
(Relative) or True bearing (requires heading data). This may be done with
“EBL REFERENCE,” which is in the RADAR DISPLAY SETUP menu.
2.11.3 Erasing an EBL, EBL indication
Press appropriate EBL soft key, then press the [CLEAR] key. The EBL is erased
and its indication becomes blank.
2.11.4 Erasing EBL/VRM data boxes
Press the EBL or VRM soft key associated with the EBL/VRM data box you wish
to erase. Press the [CLEAR] key once or twice to erase the data box.
2.11.5 Hiding EBL/VRM data boxes
Press the ZOOM & D. BOX and D. BOX ON/OFF soft keys to show or hide the
EBL/VRM data boxes.
2.11.6 Moving EBL/VRM data boxes
When an EBL/VRM data box is obscuring a target you want to see, you can
move it to another location as shown below. This cannot be done when the
EBL/VRM soft keys are shown.
1. Press the [EBL/VRM] key to turn off the EBL/VRM soft keys.
2. Using the trackball, place the cursor inside the data box you wish to move. As
the cursor enters the box it changes to a “hand.” Push the [ENTER] knob,
and the hand changes to a fist, meaning the box is correctly selected.
3. Use the trackball to move the data box to the location desired, then push the
[ENTER] knob.