Filter
Top Products
1. OPERATION
14
1.14 How to Choose a Transceiver
If your FE-800 is connected to two transceivers, you can switch between the transceivers using
the procedure below.
Note: If [FE-8020 No.2] is not enabled in the [Service Menu], this menu is not selectable.
To enable [FE-8020 No.2], consult a FURUNO technician.
1. Press the MENU/ESC key to open the Main menu.
2. Select [FE-8020 Select] using S or T, then press the ENT key. This will open a pop-up
window.
3. Select the appropriate transceiver using S or T, then press the ENT key to apply the settings
and close the pop-up window. The available options are [No.1] or [No.2].
4. Press the MENU/ESC key once to close the menu.
1.15 How to Set the Depth Below Surface (DBS)
The depth reading can be referenced from one of three points.
To choose which setting to use, do the following:
1. Press the MENU/ESC key to open the Main menu.
2. Select [Sounder] using S or T, then press the ENT key.
3. Select [DEPTH(BELOW)] using S or T, then press the ENT key. This will open a pop-up.
4. Select the location to take the depth reading from, then press ENT to apply the settings and
close the pop-up window. The available options are [Transducer], [Surface] and [Keel].
5. Press the MENU/ESC key twice to close the menu.
• Transducer Depth from transducer to seabed (requires transducer “below waterline”
measurement.)
• Surface Depth from surface to seabed (requires Draught input, see section 1.16.)
• Keel Depth from keel to seabed (requires keel depth setting. Consult your local
FURUNO dealer.)
Draught
Draught
Surface
Surface
Transducer
Keel depth
Keel