Filter
Top Products
22 GHP 10 Marine Autopilot System Installation Instructions
3. Add the included T-connector for the CCU in the NMEA 2000 network by connecting it to the side of the T-connector you
disconnected.
4. Route the included drop cable to the bottom of the T-connector you just added to your NMEA 2000 network.
If the included drop cable is not long enough, you can use a drop cable up to 20 ft. (6 m) long (not included).
5. Connect the drop cable to the T-connector and the CCU.
6. Do not power the NMEA 2000 network on until all of the GHP 10 components are installed correctly. (See page 24.)
CAUTION: If you have an existing NMEA 2000 network on your boat, it should already be connected to power. Do not connect the
included NMEA 2000 power cable to an existing NMEA 2000 network, because only one power source should be connected to a NMEA
2000 network.
Notes:
The GHC 10 is not powered by the NMEA 2000 network. It must be separately connected to the power source.
The GHC 10 must also connect to the CCU with the yellow CCU signal wire in the GHC 10 power/data cable.
To add additional sensors to your NMEA 2000 network, follow the instructions included with the sensor.
To create a basic NMEA 2000 Network for the GHC 10 and the CCU:
1. Connect the three T-connectors together by their sides.
2. The included NMEA 2000 power cable must be connected to a 12 Vdc power source through a switch. Connect to the ignition
switch of the boat if possible, or through an appropriate additional switch (not included).
3. Connect the NMEA 2000 power cable to one of the T-connectors.
4. Connect one of the included NMEA 2000 drop cables to one of the T-connectors and to the GHC 10.
5. Connect the other included NMEA 2000 drop cable to the remaining T-connector and to the CCU.
6. Connect the appropriate terminators to each end of the combined T-connectors.
7. Do not power the NMEA 2000 network on until all of the GHP 10 components are installed correctly. (See page 24.)
CAUTION: You must connect the included NMEA 2000 power cable to the boat ignition switch, or through another in-line switch. The
GHC 10 will drain your battery if it is connected directly.
Creating a Basic NMEA 2000 Network for the GHC 10 and the CCU
+
-
Drop cables
Male
terminator
T-connectors
Female
terminator
Power cable
Ignition or
in-line switch
12 Vdc battery
Fuse
GHC 10
CCU
Notes:
To add additional sensors to your NMEA 2000 network, follow the instructions included with the sensor.
The GHC 10 is not powered by the NMEA 2000 network. It must be separately connected to the power source.
The GHC 10 must also connect to the CCU with the yellow CCU signal wire in the GHC 10 power/data cable.
•
•
•
•
•
•