Filter
Top Products
7GHP 10 Marine Autopilot System Installation Instructions
SeaStar Power Assist-Enabled Boats
Notes:
Power Assist module:
It may be necessary to remove the
Power Assist module to gain access
to the ttings, the hoses, and the
bleed-tee tting.
Remove the bleed-tee tting from
the Power Assist module and
relocate it to the return port on the
pump.
2.0 L/1.2 L pump (and motor):
Install the pump to the steering lines
between the cylinder and the Power
Assist module.
Do not install the pump to the
steering lines between the helm
and the Power Assist module.
An unbalanced cylinder requires
an unbalanced valve on the pump
(See page 30)
Mount the pump horizontally if
possible. Do not mount the pump
vertically with the pump end
(hydraulic connections) down.
Shadow Drive
Mount the Shadow Drive
horizontally and as level as possible.
Install the Shadow Drive in either
the port or the starboard hydraulic
steering line.
Always install a length of hose
between the helm and the Shadow
Drive.
Do not install the Shadow Drive
directly to the helm.
Install the Shadow Drive between the helm and the Power Assist module.
Do not install the Shadow Drive between the Power Assist module and the pump.
Do not install the Shadow Drive between the Power Assist module and the cylinder.
CAUTION: Do not turn the system on until you bleed all the air from the Power Assist module, the helm, the Shadow Drive, the pump, and
all the hydraulic lines. See page 24.
•
◦
◦
•
◦
◦
◦
◦
•
◦
◦
◦
◦
◦
◦
◦
Balanced cylinder
Port tting
Starboard tting
2.0 L/1.2 L pump
(and motor)
Port line
Return line
Starboard line
Shadow drive
Helm
S R P
Bleed-tee tting
(relocate to the pump)
Sea Star
Power Assist
module
H1 H2
C2C1
Return line
Balanced cylinder
Port tting
Starboard tting
2.0 L/1.2 L pump
(and motor)
Port line
Return line
Starboard line
Shadow drive
Helm
S R P
Bleed-tee tting
(relocate to the pump)
Sea Star
Power Assist
module
H1 H2
C2C1
Return line